Ponyprog X64 Install New System

Furthermore it can be used as a low cost starter kit for PIC and AVR.

Ponyprog supports AVR, SPI eeprom, AVR micro, 12C bus 8bit eeprom, PIC 16 micro, PIC 12 micro, AT89S micro and SDE2506 eeprom family chips.

You can open any HEX, e2p, mot, csm, rom, eep, bin files and burn them to uC or PIC.

You can even backup the old program on the chip using Ponyprog.

You can save any HEX file to BIN file or eep file, BIN file to HEX file or MOT file and vice versa so you can use Ponyprog as converter too.

You can even change polarity of control lines without touching the wires using IO port setup.

You just have to copy the sys file and the allowio.exe file into your desired directory and then execute the program with the allowio prog.

Eg: for running the pony-prog you can use: allowio pony-prog.

PonyProg uses some old PortIO routines which dont work with Windows 7 x64.

Ponyprog X64 Install New System

In order to install new system files with a Windows 7 system you need to sign theses files.

After coping the files as I told into the pony-prog installed directory.

So it appears the only issue you have is the missing driver which is obviously not in the right place.

Other than having an hardware issue the only thing i can suggest is you copy the dlportio driver.sys file to the following directories windowssystemsystem32drivers,make sure its in all these directories (cos i cant remember which one it resides in)then reboot and try again.